dan90
Member
- Your Task History ID
- IjU3NjUwNTY4MDYzNzA0MzI1MjY4NTUzYzUxMzE1MTZiNTQzNTBmMzki_pc
Hi there,
This workflow adds data to google sheets.
When it fails (which is does due to read and write quotas) it should run it again.
It used to work fine and was working fine for nearly 6 months.
Now it gets 20 rows in and stops working and hits the read and write quota (used to be a lot more rows than that 60-80 rows).
It also doesn't run the failed steps again even though it is set up to run 2 times if it fails.
It now runs once and never again unless I manually tell it to do it again.
Any reason why this is happening?
So two things:
1) Only about 20 rows get done before it hits read and write quota. Even though when I manually run it I am nearly getting through all my data (60-80 rows).
2) The workflow is only running once and not running the failed steps again as per my settings.
Thanks
This workflow adds data to google sheets.
When it fails (which is does due to read and write quotas) it should run it again.
It used to work fine and was working fine for nearly 6 months.
Now it gets 20 rows in and stops working and hits the read and write quota (used to be a lot more rows than that 60-80 rows).
It also doesn't run the failed steps again even though it is set up to run 2 times if it fails.
It now runs once and never again unless I manually tell it to do it again.
Any reason why this is happening?
So two things:
1) Only about 20 rows get done before it hits read and write quota. Even though when I manually run it I am nearly getting through all my data (60-80 rows).
2) The workflow is only running once and not running the failed steps again as per my settings.
Thanks