Dynamic Values Not Pulling Through into OpenAI Action Step

[jpr]

Consent to Access & Modify

I don't authorize Pabbly Support to log in to my account.

Hi, dynamic values entered into the OpenAI action step is not pulling through from previous step. This is happening intermittently. Sometimes they pull through, sometimes they. This causes incorrect OpenAI output. The workflow show as successful but the actual result / OpenAI output is way off because dynamic values have not been fed into the prompt.

Please see video explanation - https://www.loom.com/share/ff396da1f0a84509b0578f7663521d08

Task History ID - IjU3NjUwNTZiMDYzMzA0MzQ1MjY5NTUzMDUxMzM1MTYyNTQzODBmMzgi_pc

Workflow ID - https://connect.pabbly.com/workflow...ZBD0OGlJWBVMIewMNVUcGBQF7A05ULwBFDzwAXgIqXj8#

Attached also the OpenAI INPUT data as shown in the video

 

[Preeti Paryani]

Hello @jpr,

Could you please try removing the mapping for the specific fields highlighted in your video, then re-map them at the required places, save the workflow, and click the Save & Send Test Request button? After that, kindly monitor the task history to check if the issue persists.

Please note, to assist you further we may need to access your workflow directly for testing. If you’re comfortable with this, kindly provide your consent by stating the following in your next reply:

"You have my permission to log into my Pabbly Connect account and edit the workflow, if required. Here is the registered email address associated with it."