Urgent: Workflow made by your Team: Now workflow Disabled: Confusing

[zest83]

The below message received
Pls note; the workflow has been setup as per the videos on your channel and the optimisation was done by your team - hence very confusing email received


This email is to notify you that the workflow "WABA Webhook" has been paused due to the unusual high consumption of tasks. This usually happens when your workflow is not properly optimized and consumes a much higher volume of tasks.

For now as precautionary measure, we have temporarily paused the workflow "WABA Webhook". In order to enable your workflow, we request you to kindly optimize the workflow fully and ensure that it does not have any further high consumption for tasks.

 

[Supreme]

Hey @zest83

Since the webhook rate limit, the constraint is 400 requests per minute, if it exceeds then the system might switch off the workflow.

 

[zest83]

Do I need to re-authenticate the workflow?
Or will it work once I activate it?

 

[Supreme]

Hey @zest83

You only need to switch on the workflow, if your workflow gets switched off by the system if you receive more than 400 requests per min.